Navman iCN 600series User Manual download pdf (Page 9)

iCN 600 series | User Manual

Option Two: Adhesive Tape and Screw Mount*

You can use the base plate, adhesive tape and screws supplied to mount the iCN directly into the vehicle dashboard.

Important: This is a permanent solution — the adhesive tape cannot be removed once fixed and the screws will

leave holes in your dashboard.

1. Choose a position on the dashboard where the iCN will be clearly visible by the driver. Use the alcohol swab to

ensure all surfaces are clean and dry.

2. Remove one of the backing layers from the adhesive tape and press it ﬁrmly to the underside of the base plate

for 30 seconds.

3. Press the suction cup ﬁrmly in to the base plate and press the lever down.

4. Remove the second backing layer from the adhesive tape .

5. Position the ball foot in to position on the dashboard and press down ﬁrmly for 30 seconds.

6. Fit the retainer ring inside the screw plate by sliding the four locating tabs into the corresponding slots on the

underside of the screw plate.

7. Place the screw plate over the ball foot ensuring the suction cup tab ﬁts in to the tab slot on the screw plate.

8. Use the three screws to fasten the screw plate ﬁrmly to the dashboard.

9. Press the screw caps over the screw heads.

10. Slip the locking nut over the ball foot with the ﬂat side facing upwards.

11. Snap the socket clip onto the ball foot.

12. Wind the locking nut onto the thread of the socket clip until ﬁrm.

13. Snap the iCN onto the socket clipw. Position the two locating tabs on the underside of the iCN into the

corresponding slots on the socket clip. Then push the iCN into the clip.

14. Open the antenna outwards so the GPS antenna has a clear view of the sky.

15. Plug the power adapter into the socket on the left of the iCN and the other end into the vehicle lighter socket.

*iCN 635, 650 only

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

No comments

Navman iCN 600series User Manual Page 9